IDENTEC SOLUTIONS iPOINT Si Hardware User Manual page 3

iPOINT – Hardware User Manual | 18.06.2020
Radio Frequency Compliance Statement
IDENTEC SOLUTIONS is the responsible party for the compliance of the following devices:
MODEL:
Region/Country
EUROPE:
USA:
CANADA:
The user(s) of these products are cautioned to only use accessories and peripherals approved, in advance, by
IDENTEC SOLUTIONS. The use of accessories and peripherals, other than those approved by IDENTEC
SOLUTIONS, or unauthorized changes to approved products, may void the compliance of these products and result in
the loss of the user(s) authority to operate the equipment.
European Declaration of Conformity according to RED Directive
IDENTEC SOLUTIONS AG hereby declares that the device iPOINT is in conformity with the essential requirements
of Directive 2014/53/EU. The declaration of conformity can be found at:
Radio Frequency (RF) Exposure Compliance of Radio Communication Apparatus
To satisfy FCC and ISED RF Exposure requirements for mobile devices, a separation distance of 20 cm or more should be
maintained between the antenna of this device and persons during operation. To ensure compliance, operation at closer than
this distance is not recommended. This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
Conformité à l'exposition aux champs RF des équipements radio
Pour satisfaire aux exigences FCC et ISED concernant l'exposition aux champs RF pour les appareils mobile, une distance
de séparation de 20 cm ou plus doit être maintenu entre l'antenne de ce dispositif et les personnes pendant le
fonctionnement. Pour assurer la conformité, il est déconseillé d'utiliser cet équipement à une distance inférieure. Cet émetteur
ne doit pas être co-situé ou fonctionner conjointement avec une autre antenne ou un autre émetteur.
Canada Certification
Licence-Exempt Radio Apparatus (ISED)
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:
1.This device may not cause interference.
2.This device must accept any interference, including interference that may cause undesired operation of the device.
Appareils radio exempts de licence (ISDE)
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation,
Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes :
1.L'appareil ne doit pas produire de brouillage;
2.L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre
le fonctionnement.
Copyright © 2020 IDENTEC SOLUTIONS. All rights reserved.
Organization
EU
FCC
IC
IDS1001 iPOINT Si
Marking
CE
FCC ID OO4-IDS1001
3538A-IDS1001
www.identecsolutions.com
3