Gigabyte Z590 AORUS XTREME WB User Manual page 24

RJ-45 LAN Port (LAN1)
The Gigabit Ethernet LAN port provides Internet connection at up to 10 Gbps data rate. The following
describes the states of the LAN port LEDs.
Connection/
Speed LED Activity LED Speed LED:
State
Green
Orange
LAN Port
USB 3.2 Gen 2 Type-A Port (Red) (Q-Flash Plus Port)
The USB 3.2 Gen 2 port supports the USB 3.2 Gen 2 specification and is compatible to the USB 3.2 Gen 1
and USB 2.0 specification. Use this port for USB devices. Before using Q-Flash Plus
the USB flash drive into this port first.
HDMI Port
You can use this port to connect your HDMI-supported monitor. The maximum supported resolution is
4096x2160@30 Hz, but the actual resolutions supported are dependent on the monitor being used.
After installing the HDMI device, make sure to set the default sound playback device to HDMI.
(The item name may differ depending on your operating system.)
Center/Subwoofer Speaker Out
Use this audio jack to connect center/subwoofer speakers.
Rear Speaker Out
Use this audio jack to connect rear speakers.
Optical S/PDIF Out Connector
This connector provides digital audio out to an external audio system that supports digital optical audio.
Before using this feature, ensure that your audio system provides an optical digital audio in connector.
Line In/Side Speaker Out
The line in jack. Use this audio jack for line in devices such as an optical drive, walkman, etc.
Line Out/Front Speaker Out
The line out jack.
Mic In
The Mic in jack.
Audio Jack Configurations:
Jack
Center/Subwoofer Speaker Out
Rear Speaker Out
Line In/Side Speaker Out
Line Out/Front Speaker Out
Mic In
If you want to install a Side Speaker, you need to retask the Line in jack to be Side Speaker out
through the audio driver.
• When removing the cable connected to a back panel connector, first remove the cable from your
device and then remove it from the motherboard.
• When removing the cable, pull it straight out from the connector. Do not rock it side to side to
prevent an electrical short inside the cable connector.
(Note) To enable Q-Flash Plus function, refer to Chapter 5, "Unique Features," for more information.
Hardware Installation
Description
10 Gbps data rate
5 Gbps/ 2.5 Gbps/ 1 Gbps/
100 Mbps data rate
The HDMI port supports HDCP 2.3 and Dolby TrueHD and DTS HD Master Audio
formats. It also supports up to 192KHz/16bit 7.1-channel LPCM audio output.
Headphone/2-channel
a
- 24 -
Connection/Activity LED:
State Description
Blinking Data transmission or receiving is occurring
On No data transmission or receiving is occurring
, make sure to insert
(Note)
4-channel 5.1-channel
a
a a
a a
7.1-channel
a
a
a
a
a