Leveling - True TOAM-48GS-HC~TSL01 Installation Manual

Installation (cont.)
Cabinet Location
1. Ensure that the drain hose or hoses are positioned in the pan.
2. Free the plug and cord from inside the lower rear of the cooler
(DO NOT plug in).
3. Place the unit close enough to the electrical supply so that the
extension cords are never used.
Installing Standard Leveling Legs
Leveling legs are provided to assist with the leveling of the cabinet.
1. Access the bottom of the cabinet and locate the
leveling legs.
2. The leveling legs may be threaded in or out to
achieve a level and supported cabinet.
See fig. 1 and 2.
Installing Optional 6" Leveling Legs or Castors
Optional adjustable legs will provide 6" (152 mm) of clearance
under the cabinet. Optional castors will provide cabinet mobility.
Tools Required
• Adjustable Wrench
• Castor wrench (optional)
6" Leveling Legs
1. Access the bottom of the cabinet by carefully laying it on
its back. Locate and remove the leveling legs from the 1/2"
threaded inserts. See fig. 3.
2. Screw in the leveling legs. See fig. 4.
3. Verify that the cabinet is level. If the cabinet is not level,
gently lift and support the low end of the cabinet. Using an
adjustable wrench, screw the bottom stem of the leveling leg
in or out to level and support the cabinet. See fig. 5.
Castors
1. Loosen the castor bolt enough to slide the provided castor
shims between the castor bearing and the bottom rail of
the cabinet. See fig. 6.
2. Install the desired number of shims. If more than one shim is
used, turn the slots at a 90˚ angle to each other, so the slots do
not align. See figs. 7 and 8.
3. Tighten and secure the shims and castors with the optional
castor wrench. Lower the cabinet and verify that it is level. If
the cabinet is not level, repeat the process until the cabinet is
level and supported.
– Units may pose a tipping hazard
WARNING
while uncrating, during installation, or when
moving the unit.
TEC_TM_012 REV. B
TOAM | OPEN AIR MERCHANDISER
Fig. 1. Turn the leveling legs clockwise
to lower the unit.
Fig. 3. Locate the threaded hole in the
rail.
Fig. 5. Turn the bottom stem to level the
cabinet.
Fig. 6. Loosen castor bolt.
Fig. 8. Position multiple shims at
90˚ angles.
09/25/2020
truemfg.com
Fig. 2. Turn the leveling legs
counterclockwise to raise the unit.
Fig. 4. Screw in the leveling legs.
Lower Rail
Assembly
Rail End
Snug Fit
Here
Leg
Bottom Stem
Fig. 7. Install shim(s).
Castor Stem
Lower Rail Assembly
Rail End
Snug Fit Here
Bearing Race
Leveling Shim
Castor
Page 7 of 20