Draytek Vigor2866 Series Quick Start Manual page 5

User Manual Information Agreement
This equipment complies with Part 68 of the FCC rules. Located on the equipment is a label that
contains, among other information, the ACTA registration number and ringer equivalence number
(REN.) If requested, this information must be provided to the telephone company.
The REN is used to determine the quantity of devices which may be connected to the telephone line.
Excessive REN's on the telephone line may result in the devices not ringing in response to an incoming
call. In most, but not all areas, the sum of the REN's should not exceed five (5.0). To be certain of the
number of devices that may be connected to the line, as determined by the total REN's contact the
telephone company to determine the maximum REN for the calling area.
This equipment cannot be used on the telephone company-provided coin service. Connection to Party
Line Service is subject to State Tariffs.
If this equipment causes harm to the telephone network, the telephone company will notify you in
advance that temporary discontinuance of service may be required. If advance notice isn't practical,
the telephone company will notify the customer as soon as possible. Also, you will be advised of your
right the file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations, or procedures
that could affect the operation of the equipment. If this happens, the telephone company will
provide advance notice in order for you to make the necessary modifications in order to maintain
uninterrupted service.
If trouble is experienced with this equipment, please contact:
Company Name: ABP International Inc.
Address: 13988 Diplomat Drive Suite 180 Dallas TX75234
TEL: 1-972-831-1600
FAX:
If the trouble is causing harm to the telephone network, the telephone company may request you to
remove the equipment from the network until the problem is resolved.
This equipment uses the following USOC jacks: RJ11
It is recommended that the customer install an AC surge arrester in the AC outlet to which this device
is connected. This is to avoid damaging the equipment caused by local lightening strikes and other
electrical surges.
iii