ring Contact Sensor 2nd Generation Z-Wave Technical Manual page 5

Ring Alarm Contact Sensor – Inclusion
Adding Ring Alarm Contact Sensor to a Z-Wave Network
Ring Alarm Contact Sensor can be added via SmartStart or Classic inclusion mode.
Note
When prompted for the QR Code or PIN, you may find them on the device, on the box, or on a card
inside the box. Keep the device nearby. You'll be prompted to pull the battery tab to power on the
device and enter setup mode.
SmartStart Inclusion Steps:
1. Initiate the add flow for Security Devices in the Ring mobile application – Follow the guided add flow
instructions provided in the Ring mobile application.
2. When prompted by the mobile application, scan the QR code found on the package of the
Contact Sensor. The QR code can also be found on the device itself.
3. Pull the pull-tab or insert batteries, and the device will go into SmartStart inclusion mode. While in
this mode, Contact Sensor can be added to a Z-Wave controller that supports SmartStart. When in
SmartStart inclusion mode, SmartStart can be restarted by tapping the button on the front of
the device.
Classic Inclusion Steps:
Classic Inclusion should be used if the controller does not support SmartStart.
1. Initiate add flow for Security Devices in the Ring mobile application – Follow the guided add flow
instructions provided in the Ring mobile application.
2. Select add manually and enter the 5-digit DSK PIN found on the package of the Ring Alarm Contact
Sensor or the 5-digit DSK PIN found under the QR code on the device.
3. After powering on the device, press and hold the button on the front of the device for ~3 seconds.
Release the button and the device will enter Classic inclusion mode which implements both classic
inclusion with a Node Information Frame, and Network Wide Inclusion. During Classic Inclusion
mode, the green LED will blink three times followed by a brief pause, repeatedly. When Classic
inclusion times-out, the device will blink alternating red and green a few times.
LED Behabior for Inclusion
SmartStart Started
Classic Inclusion Started
Classic Inclusion Timed-Out
Inclusion Successful (Authenticated S2)
Inclusion Not Successful (Self-Destruct)
Blink Pattern
Green LED three times, repeated after a brief pause
Green LED three times, repeated after a brief pause
Alternate red and green a few times
Green LED on solid
Red LED on solid
5