ring Contact Sensor 2nd Generation Z-Wave Technical Manual page 8

Configuration Command Class
The sensor has the following supported configuration parameters.
Parameter
Description
Number
Heartbeats:
This parameter is the number min-
1 utes between heartbeats. Heart-
beats are automatic battery reports
on a timer after the last event.
Number of application level retries
attempted for messages either not
2 ACKed or messages encapsulated
via supervision get that did not
receive a report.
Application Level Retry Base Wait
Time Period: The number base
3
seconds used in the calculation for
sleeping between retry messages.
This parameter allows a user, via
software, to configure the various
LED indications on the device.
0 == Don't show green
4 1 == Show green after Supervision
Report Intrusion (Fault)
2 == Show green after Supervision
Report both Intrusion and Intrusion
clear
One shot timer: Writing to this
parameter prompts the sensor to
send a wakeup notification one
5
time after this parameter's number
of seconds. After which it is reset
back to 0.
The number of milliseconds
waiting for a Supervisory Report
6 response to a Supervisory Get
encapsulated command from the
sensor before attempting a retry.
8
Number
of Default
Bytes
1 70 (0x46)
1 1 (0x01)
1 5 (0x05)
1 1 (0x01)
2 0 (0x00)
1500
2
(0x5DC)
Min Max
1 (0x01) 70 (0x46)
0 (0x00) 5 (0x05)
1 (0x01) 60 (0x3C)
0 (0x00) 2 (0x01)
65535
5 (0x05)
(0xFFFF)
5000
500 (0x1F4)
(0x1388)
Format
0x01
Unsigned
0x01
Unsigned
0x01
Unsigned
enum
0x01
Unsigned
0x01
Unsigned