Table of Contents
Advertisement
en Troubleshooting
Fault
The time flashes in the display.
The time does not appear in the
display when the appliance is
switched off.
lights up in the display and no
settings can be made on the ap-
pliance.
flashes in the display and the
appliance will not start.
appears in the display.
-
appears in the display.
A message with appears in the
display, e.g.
-
.
lights up permanently in the
display.
lights up in the display.
appears in the display.
During operation with steam as-
sistance, steam escapes from the
ventilation slots.
34
Cause and troubleshooting
There has been a power cut.
Reset the time.
▶
→ "Setting the time on the clock", Page 15
The basic setting has been changed.
Change the basic setting for the time display.
▶
→ "Basic settings", Page 21
Childproof lock is activated.
Use the
button to deactivate the childproof lock.
▶
→ "Childproof lock", Page 20
The cooking compartment is too hot for the selected operation.
Switch off the appliance and allow it to cool down.
1.
Restart the operation.
2.
The maximum cooking time has been reached. To prevent an unwanted per-
manent operation, the appliance automatically stops heating after several hours
if the settings are unchanged.
Switch off the appliance.
▶
You can configure new settings if required.
Tip: To prevent the appliance from switching off when you do not want it to,
e.g. for an extremely long preparation time, set a cooking time.
→ "Time-setting options", Page 14
There is too much water in the steam system. The water cannot be pumped
back into the water tank.
Empty the water tank and insert the empty water tank.
1.
→ "Emptying the water tank", Page 13
Reset the time.
2.
→ "Setting the time on the clock", Page 15
Switch the appliance off and on again.
3.
Run "Descaling interrupted" in full.
4.
→ "Descaling interrupted", Page 28
Electronics fault
1.
Press the
button.
If required, reset the time.
‒
a If the fault was a one-off, the error message disappears.
If the error message appears again, call the after-sales service. Quote the ex-
2.
act error message and the E no. of your appliance.
→ "Customer Service", Page 36
The water tank is empty.
Fill the water tank.
▶
→ "Filling the water tank", Page 13
The water tank has not been put in fully.
Slide the water tank back in fully.
▶
The water tank is leaking.
Order a new water tank.
▶
The sensor is defective.
Call the after-sales service.
▶
→ "Customer Service", Page 36
Build-up of limescale in the appliance.
Run the descaling programme in full.
▶
→ "Descaling", Page 27
The power supply has been disconnected or the appliance has been switched
off during the descaling process.
Run the interrupted descaling programme in full.
▶
→ "Descaling interrupted", Page 28
Steam escapes for physical reasons.
Wait until the cooking with steam assistance ends.
▶
After the end of cooking with steam assistance, no more steam will escape
after a short time.
Advertisement
Table of Contents
