Table of Contents
Advertisement
Notes
¡ Depending on the appliance type, you must change
the basic settings for the telescopic rails for appli-
ances with rails and pull-out rails.
→ "Basic settings", Page 21
¡ If necessary, you can use pull-out rails on all levels.
Push on the tab marked PUSH behind the rail, and
1.
push the rail to the rear.
Keep the PUSH tab pushed back
2.
rail outwards
.
Pull the rail out towards the front until the retainer at
3.
the back unhooks.
Remove the pull-out rail.
4.
5.
20.4 Attaching the pull-out rail
Note: The pull-out rails only fit on the right or left. Make
sure when you fit them that you can pull them out to-
wards the front.
1.
and swing the
2.
3.
a The retainer
Clean the pull-out rail.
→ "Cleaning products", Page 24
Insert the pull-out rail between the two bars.
Push the retainer
in between the lower and the
upper bar.
Keep the PUSH tab pushed in
out rail inwards until the front retainer
between the two bars
Release the PUSH tab.
‒
clicks into place.
Shelf supports en
and swing the pull-
is located
.
29
Advertisement
Table of Contents
