Piston Ring / Connecting Rod Specifications - Toro LC1P65FC Service Manual

Piston Ring End Gap
Use the piston to position the rings squarely 1" down from the
top of the cylinder.
Standard
0.0078 - 0.0157"
(0.2-0.4 mm)
NOTE: If this measurement is out of specification, complete engine
replacement is required. The only internal parts available for this engine are gaskets and seals.
Connecting Rod Small End ID
Standard
0.5125"
(13.02 mm)
NOTE: If this measurement is out of specification, complete engine replacement
is required. The only internal parts available for this engine are gaskets and
seals.
Connecting Rod Big End ID
Standard
1.0244"
(26.02 mm)
NOTE: If this measurement is out of specification, complete engine replacement is
required. The only internal parts available for this engine are gaskets and seals.
Service Limit
0.0393"
(1.0 mm)
Service Limit
0.5145"
(13.07 mm)
Service Limit
1.0263"
(26.07 mm)
34