Before Using For The First Time; Control And Display Elements; Safety Devices; Base Unit - Bosch SmartPower MFW25 Series Instruction Manual

Before using for the first time

Before the new appliance can be used,
it must be fully unpacked, cleaned and
checked.
Caution!
Never operate a damaged appliance!
■ Remove the base unit and all
accessories from the packaging.
■ Remove the packaging material that is
present.
■ Dismantle any assembled parts into
their individual parts. Do this in reverse
order, as described under „Preparation".
■ Check all parts for completeness.
X Fig. A
■ Inspect all parts for visible damage.
■ Thoroughly clean and dry all parts
before using for the first time.
X "Care and daily cleaning" see
page 26
Control and display
elements
Button k
Press button k to switch on the appliance.
The drive will start up at once. Press button
k again to switch off the appliance. The
drive stops.
Release button
Press the release button to unlock an
attachment fitted on the appliance. Only
when the release button is pressed is it
possible to turn the attachment clockwise
and remove it from the base unit.

Safety devices

Thermal circuit breaker
If the motor switches itself off while the
appliance is being used, the overload
protection feature has been activated.
Possible causes may be the simultaneous
processing of large quantities of food or a
blockage caused by bones.
X "Troubleshooting" see page 30
Before using for the first time
Overload protection
To prevent serious damage to your
appliance if the base attachment is
overloaded, the agitator paddle has a
notch (predetermined breaking point). If
overloading occurs, the agitator paddle
will break at this point. A new agitator
paddle is available from Customer
Service (No. 10011109). Spare parts with
a predetermined breaking point are not
covered by our warranty obligations.
Replace agitator paddle
X Fig. E
1. Release the screw in the agitator paddle
with a screwdriver (PH2) and remove
the faulty paddle.
2. Fit a new agitator paddle and screw tight
again.

Base unit

Preparation
W Risk of injury!
Do not insert the mains plug until all
preparations for working with the appliance
are complete and the required attachments
are assembled correctly and connected to
the base unit.
■ Place the base unit on a stable and level
work surface.
The base unit is now prepared.

Base attachment

The base attachment can be used for the
following applications:
Meat mincer
For mincing raw or cooked food. Select the
appropriate perforated disc depending on
the type and consistency of the food to be
processed. X "Tips" see page 28
Sausage filler
For filling artificial and natural casings with
sausage meat. For producing meat rolls.
Kebbe maker
For producing tubes of dough or minced meat.
en
23