Advertisement
DALI gateway Tunable White Plus
–
Corridor function: when combined with motion detectors, reduced continuous lighting, if
no motion is detected
–
Online or offline project design of the DALI devices with ETS plug-in
–
Short circuit protection
–
Surge protection
–
Overload protection
–
Operating hours counter
–
Signal of the global switching status of the DALI devices, e.g. to switch off the mains
voltage of the DALI devices to avoid standby losses
–
An individual DALI device can be exchanged during operation without software.
–
With device generation I03 or higher: DALI-2 certified.
Delivery state: construction site mode, the DALI groups can be operated using button
field. All DALI devices are controlled jointly.
3
Operation
See illustration of the button field (Figure 1).
(1)
Button c – Manual operation
(2)
LED c – On: Continuous manual mode active
Button ON/n switch on or increase brightness
(3)
LED ON/n On: DALI device or group switched on, brightness 1...100 %
(4)
Button OFF/o switch off or reduce brightness
(5)
LED OFF/o On: DALI device or group switched off, brightness 0 %
(6)
(7)
Button ALL OFF – Switch off all DALI devices
(8)
Display of DALI number (1...64)
(8a)
Display of the DALI group
(8b)
Display of the individual DALI device
If the display shows (8) bc (Broadcast operation), the device is not programmed or set to
master control in the KNX configuration. All DALI devices are then controlled jointly.
In operation with the button field the device distinguishes between a short and a long press.
–
Short: Pressing for less than 1 second
–
Long: Pressing for between 1 and 5 seconds
Switching on the temporary manual control
Operation using the button field is programmed and not disabled.
82596912
15.06.2020
Figure 1
2 / 7
Advertisement
