Table of Contents
Advertisement
Available languages
Available languages
Ventilation
The air on the rear panel of the appliance
heats up. Conduction of the heated air
must not be obstructed. Otherwise, the
refrigeration unit must work harder. This
increases power consumption.
Therefore: Never cover or block the
ventilation openings!
Cavity depth
A cavity depth of 560 mm is recom-
mended for the appliance. If the cavity
depth is smaller – at least 550 mm – the
energy consumption increases slightly.
Connecting
the appliance
After installing the appliance, wait at least
1 hour until the appliance is switched on.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior of the
appliance (see chapter "Cleaning the
appliance").
Electrical connection
The socket must be near the appliance
and also freely accessible following
installation of the appliance.
The appliance complies with the
protection class I. Connect the appliance
to 220–240 V/50 Hz alternating current
via a correctly installed socket with
protective conductor. The socket must
be fused with a 10 to 16 A fuse.
For appliances operated in non-
European countries, check whether the
stated voltage and current type match
the values of your mains supply. This
information can be found on the rating
plate. Fig. *
Getting to know your
appliance
Please fold out the illustrated last page.
These operating instructions refer
to several models.
The features of the models may vary.
The diagrams may differ.
Fig. ç !
A
Refrigerator compartment
B
Freezer compartment
1
Temperature controller/light
2
Light switch
3
Glass shelf in the refrigerator
compartment
4
Vegetable container
5
Frozen food container
6
Door shelf
7
Shelf for large bottles
en
23
Advertisement
Table of Contents
