Register Your Product; Package Content; Connectors; Connecting Loudspeakers - Genelec 4420A Quick Setup Manual

1 REGISTER YOUR PRODUCT

Please register your loudspeaker at www.community.genelec.com and learn
more about warranty. Consider joining the Genelec Community, as then you'll be
able to ask questions, share experiences and participate in discussions with
Genelec users globally. More information about service and technical support is
available at www.genelec.com/customer-service.

2 PACKAGE CONTENT

•
Genelec two-way active loudspeaker 4420A. This is PoE+ powered bi-
amplified audio-over-IP capable loudspeaker for installed audio
applications.
•
Keyhole-type wall mount with screws.
•
Three-pin Euroblock connector for balanced analogue line input (inserted
in the loudspeaker).

3 CONNECTORS

Ethernet port
•
PoE+ power input
(IEEE 802.3at)
•
Management over
Ethernet
•
Audio-over-IP
stream input

4 CONNECTING LOUDSPEAKERS

To get started, connect an Ethernet cable from the PoE+ output in an IP switch to
the 4420A Ethernet port. Press the power switch to power up the loudspeaker.
To create a working system, you will need
•
IP switch with a PoE+ (802.3at) output for the 4420A loudspeaker
or an IP switch with no PoE support and a PoE+ power injector
•
CAT 5 or higher category Ethernet cable with RJ45 connectors
•
AES67, ST2110 or Dante audio-over-IP stream source
Power on/off
Reset to factory settings
push and hold for 10
seconds
Balanced analogue
line input