How To Use The Remote Control; Temperature Control; Function Control - Friedrich X-Star XQ05L10A Installation And Operation Manual

How to use the remote control

To start unit
1 POWER - Press the Power button once. The unit will automatically
start in the mode and fan speed it was last left on.
To set mode of operation
2 COOL - Press the Cool button to automatically switch the operating
mode to COOL.
3 FAN ONLY - Press the Fan Only button if you want to run the fan
only.
®
4 MoneySaver - Press the MoneySaver
MoneySaver ® feature. This feature cycles the fan with the compres-
sor so that the fan does not run all the time.
To adjust temperature setting
5
WARMER - Press the
setting.
6 COOLER - Press the
setting.
To adjust fan speed
7 FAN SPEED - Press the Fan Speed button to see the current set-
ting. Press again to change the fan speed. F1 is the lowest setting
(SLEEP / LOW), F2 is MEDIUM, F3 is HIGH, and SF is the SMART
FAN setting.
To set the hour clock
8 SET HOUR CLOCK - Press Set Hr. once to see the current clock
setting. Continue pressing the button until you arrive at the current
time (Hour only). Minutes are not shown on the display. Make sure
that the A.M. / P.M. setting is correct.
How to operate your Friedrich room air conditioner
Model YQ07
This model is designed for use in warmer climates; therefore it does not have
back-up electric heat and will not provide adequate heating below an outdoor
ambient temperature of 37°F (3° C).

Function control

The left knob is a six position control that allows you to select heat or cool in
either low speed or high speed. Plus you can select fan only if you wish.

Temperature control

T e h g i r t h a h d n n k b o s i h t t e e h m r
c c o l w k e s i r o f a w m r r e S ( e e i F u g e r
®
button to activate the
Warmer button to raise the temperature
Cooler button to lower the temperature
s o a t - t u t n r c t i c o l w k e s i o f c r o o r e l
. ) 5
920-197-01
To set the timer
NOTE: You can set the START and STOP times a minimum of one hour
apart, and a maximum of 23 hours apart.
9 TIMER START - Press Start
Continue pressing the Start button until you arrive at the start time
you desire. The start time for cooling will then be set.
10 TIMER STOP - Press the Stop button. Continue pressing the Stop
button until you arrive at the stop time you desire. The stop time for
cooling will then be set.
11 TIMER ON / OFF - Press the On/Off button to activate (light on) or
deactivate (light off) the timer. Once the on and off times have been
selected, they will remain in memory and cycle daily until changed.
NOTE: If the unit is unplugged or the power is interrupted, the Set Hr.
function must be reset or the On/Off function will not work.
Figure 4
6
2
3
11
9
Additional RC1 wireless remote controls can be purchased from your Friedrich dealer.
High
Heat
Low
Heat
c , u o t n - r e
!
Figure 5
o t i v w e h t c e
Temperature
Cooler Warmer
Cool
Power
Fan Fan Money
Only Speed Saver ®
Timer Operation
On/Off Start Stop Set Hr.
(YQ07 / EQ08 models)
MAX
HEAT
Off
Fan
Only
High
Cool
MAX
Low
COOL
Cool
Allow 3 min. between restarts
r r u n e s t a t t t r m i e o f c r o o n i l . g
5
1
4
7
8
10
5