Before You Call For Service; Trouble Shooting Tips; Normal Operation; Abnormal Operation - Friedrich Uni-Fit US08C10 Installation And Operation Manual

Thru-the-wall series 115 & 230 volts
Hide thumbs Also See for Uni-Fit US08C10:
Table of Contents

Advertisement

Available languages

Available languages

Before you call for service...

Trouble Shooting Tips

Troubleshooting Tips Save Time and Money!
Review the chart below first and you may not need to call for service.

Normal Operation

• You may hear a pinging noise caused by water being picked up and thrown against the condenser
on rainy days or when the humidity is high. This design feature helps remove moisture and improve
efficiency.
• You may hear the thermostat click when the compressor cycles on and off.
• Water will collect in the base pan during high humidity or on rainy days. The water may overflow
and drip from the outdoor side of the unit.
• The fan may run even when the compressor does not.

Abnormal Operation

Problem
Air conditioner
does not start
Air conditioner
does not cool as it
should
Air conditioner
freezing up
Possible Causes
The air conditioner is
unplugged.
The fuse is blown/circuit
breaker is tripped.
Power failure.
Airflow is restricted.
The THERMOSTAT may
not be set high enough.
The air filter is dirty.
The room may have been
hot.
Cold air is escaping.
Cooling coils have iced up.
Ice blocks the air flow and
stops the air conditioner
from cooling the room.
What To Do
• Make sure the air conditioner plug is pushed
completely into the outlet.
• Check the house fuse/circuit breaker box and
replace the fuse or reset the breaker.
• If power failure occurs, turn the mode control to OFF.
When power is restored, wait 3 minutes to restart the
air conditioner to prevent tripping of the compressor
overload.
• Make sure there are no curtains, blinds, or furniture
blocking the front of the air conditioner.
• Push temperature setting button to the coolest
temperature setting 60.
• Clean the filter at least every 2 weeks.
See the operating instructions section.
• When the air conditioner is first turned on,
you need to allow time for the room to cool down.
• Check for open furnace floor registers
and cold air returns.
• Set the air conditioner's vent to the closed position.
• See Air Conditioner Freezing Up below.
• Set the mode control at Med Fan or High Cool with
the thermostat towards the left.
18

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents