Advertisement
Note: When installing the brackets and bars, all hardware must be left loose until all the items are attached.
1.
Remove all contents from
the package and check
stainless steel tubes for any
damage. Also, verify that all
components and hardware
listed above are included
before you begin installation.
2.
Read installation manual
and installation drawing
completely. Understand all
brackets and bolts before
installation.
3.
Begin installation on the
drivers's side. Front and
Center Bracket Cradle face to
the rear of truck and Rear
Bracket Cradle faces to front
of truck.
4.
Existing mounting holes
are located on the interior
wall of the rocker panel.
These mounting holes will be
used per the following
instruction.
F r o
4
INTERIOR
WALL OF
ROCKER PANEL
2
Rev 1
n t
PLUG
EXISTING
MOUNTING
HOLE
RTS25CH
Advertisement
