Main Level - KETRON SD40 Instruction Manual

Controls
of variables of the percussion instruments during performance.
USB MIDI IN KEYBOARD:
selection function is inserted. If you connect a midi usb device (for example a midi keyboard), this function allows
you to assign the receiving port to the MIDI KEYBOARD or to the MIDI GM (can be saved in CUSTOM
STARTUP).
SPLIT LOCK
-
ASSIGN VOL.5 TO LOWER
num. 5 RIGHT. The CHORD volume in this mode only acts in automatic Chords. The function can be saved in
CUSTOM STARTUP
DRY ON STOP
-
utility, the singer will not have to turn off the effect manually in the case of any presentations, comments etc etc.
MAIN TRNSP ON PLAYER
-
transposition on Voice / Arranger Section which will be shared with the PLAYER section. With the unchecked
(blue) selection Transposer will operate only on the Voice / Arranger Section without affecting the PLAYER
Section

MAIN LEVEL

-
relevant box or the corresponding virtual knob using the Dial. The main output may also be muted.
AUX / HEADPHONE LEVEL
-
Mute them, following the steps described for the Main Level.
FADE:
- Inserted MENU → CONTROLS → Fade Mode function that sets different fading speeds, Normal,
Slow1, Slow2, Fast1, Fast2. Can be saved on Custom start up.
https://www.ketron.it/images/ketron/Manuali_HTML/SD40/english/15_controls.html[13/05/2020 17:02:13]
On MENU → CONTROLS, the USB MIDI IN KEYBOARD or GM
: Allows to"lock" the Split on Player Mode.
: Apply ByPass effect (DRY) on the microphone when the Player is on STOP. With this
: This is the main volume of the instrument that may be set on this menu either by using the
:Allows to change the volume of the Lowers by a potentiometer
: With the selected function (yellow icon) using the transpose applies
: On this menu you may adjust the volume of the headphones or
MENU