Control Panel - Emotiva Airmotiv RS13 User Manual

Control Panel (top)
The configuration controls on the Airmotiv RS13 and RS11 Reference Subwoofers are located
under a tinted plastic cover located near the rear of the top panel. The cover is attached
magnetically - simply lift to remove it and access the controls.
1. X-Over (Crossover Frequency)
This control sets the low-pass crossover frequency for the internal crossover on the Reference
Subwoofer. This is used to configure the smoothest possible blend between the Reference
Subwoofer and your main speakers.
2. Phase
This control allows you to adjust the phase of the acoustic output on the Reference Subwoofer
relative to your main speakers. This is used to adjust your Reference Subwoofer so it is "in phase"
with your main speakers.
Note: The X-Over and Phase controls only affect the output of the Reference Subwoofer when
the X-Over Switch is set to In. They have no effect when the X-Over Switch is set to Out, and they
have no effect on the Loop output.
AIRMOTIV R
efeRence
X-OVER PHASE LEVEL
X-OVER EQ POWER STATUS
90 Hz -90'
IN DEEP AUTO
60 Hz 110 Hz
OUT FLAT ON
40 Hz 160 Hz 0' -180' -20 dB +15 dB
60 Hz
40 Hz 160 Hz
S
ubwOOfeRS
1 2 3
X-OVER PHASE LEVEL
90 Hz -90'
110 Hz
0' -180' -20 dB +15 dB
Page 14
4
X-OVER EQ POWER STATUS
IN DEEP AUTO
OUT FLAT ON
5 6 7