Connection To Evaluation Devices - Pilz PSEN cs5.1 M12/8 Operating Manual

PSEN cs5.1 M12/8
PIN
7
8
The wire colour also applies for the cable available from Pilz as an accessory.

Connection to evaluation devices

Make sure that the selected evaluation device has the following property:
}
OSSD signals are evaluated through 2 channels with feasibility monitoring
Please note:
}
Information given in the
}
The use of Safety Device Diagnostics is described in the System Description "Safety
Device Diagnostics".
Operating Manual PSEN cs5.1 M12/8
1003419-EN-06
Connection
designation Function
A2 0 V UB
Y1 Diagnostics input
Technical details [
CAUTION!
Do not connect the signal output to 0 V!
If the signal output Y32 is connected to 0 V, the safety switch may be dam-
aged as a result. Connect the signal output Y32 to a consumer, e.g. to the
input on a control system, or leave the signal output unconnected. Also note
the max. current (see Technical details [
Wire colour
blue
red
33] must be followed.
33]).
18