Step 2, Slide Oven Into Cutout; Step 3, Install Bottom Trim; Step 4, Install Mounting Screws; Step 5, Finalize Installation - Monogram Advantium ZSB9121NSS Installation Instructions Manual

2 SLIDE OVEN INTO CUTOUT
Two people are required to
CAUTION
lift the oven into the opening.
Grasp the bottom at the front and rear. DO
NOT USE THE HANDLE TO LIFT THE OVEN.
DAMAGE WILL OCCUR!
• Lift and hold the oven at the front of the
opening.
Hold the oven at a 45º angle and plug in the power
cord.
• Carefully, slide the oven into the cabinet part way.
Leave the oven a few inches forward of the
cabinet frame.
• Check to be sure the power cord is not trapped
under the oven or along the sides of the oven.
3
INSTALL BOTTOM TRIM
• Align bottom trim tabs to slots in the bottom of the
oven.
• Secure the bottom trim to the bottom of the oven
using 3 brass screws provided.
12
Installation Instructions
INSTALL MOUNTING SCREWS
4
• Slide the oven the remaining way into the
opening so that the side flanges and control
panel are against the cabinet frame. Make sure
that the oven is centered in the opening.
• Open the door, place a turntable tray in the
oven and make sure that the tray in the unit is
level.
• Drill pilot holes through the side flanges.
• Drive the color-matched screws into the side
flanges. It is recommended that the screws
be hand tightened..
FINALIZE INSTALLATION
5
• Turn power on at the source. The interior light
should come on when the door is opened.
• Refer to the Owner's Manual for operating
instructions.
31-7000078 Rev. 0