Connecting To An Antenna Or Cable; Other Connections; Remote Control - LG 43UW660H Owner's Manual

Connecting to an Antenna or Cable

Connect an antenna, cable, or cable box to watch
TV while referring to the following. The illustrations
may differ from the actual items and an RF cable is
optional.
CAUTION
• Make sure not to bend the copper wire of the RF
cable.
Copper wire
• Complete all connections between devices, and
then connect the power cord to the power outlet
to prevent damage to your TV.
NOTE
• Use a signal splitter to use 2 TVs or more.
• DTV Audio Supported Codec: MPEG, Dolby Digital.
• Direct ULTRA HD broadcast is unavailable in
areas without an ULTRA HD signal.
• This TV cannot receive ULTRA HD (3840 x 2160
pixels) broadcasts directly because the related
standards have not been confirmed. (Depending
upon model)

Other Connections

Connect your TV to external devices. For the best
picture and audio quality, connect the external
device and the TV with the HDMI cable.
NOTE
• Use only with the 3 pole 3.5 mm stereo jack.
• Do not connect your headphones or earphones
to the port for connecting an external speaker.

Remote Control

The descriptions in this manual are based on
the buttons on the remote control. Please read
this manual carefully and use the TV correctly. To
install batteries, open the battery cover, replace
batteries (1.5 V AAA) matching the
to the label inside the compartment, and close the
battery cover. Failure to match the correct polarities
of the battery may cause the battery to burst or
leak, resulting in fire, personal injury, or ambient
pollution. To remove the batteries, perform the
installation actions in reverse. This remote uses
infrared light. When in use, it should be pointed in
the direction of the TV's remote sensor.
12
A
(Power) Turns the TV on or off.
Number button Enters numbers. Also supports
characters.
(Dash) Inserts a dash between numbers such as
2-1 and 2-2.
viewed.
input modes.
Program) feature can also be enabled by pressing
the key.
and ends
Accesses the Smart menu.
Selects the remote's operating mode: TV.
Selects the remote's operating mode: DVD.
INPUT Changes the input source.
Turns the TV off in a set amount of time.
Tunes to the last channel or input
Adjusts the volume level.
Switches between Letter and Number
Selects a closed caption.
Enables VD function. SAP (Secondary Audio
Deletes letters or numbers.
Mutes all sounds.
Scrolls through the saved channels.
Moves to the previous or next screen.
A