Advertisement
6. TROUBLESHOOTING GUIDE
SYMPTOMS
Pump does not reach required pressure
Fluctuating pressure
Water or oil leaks
Motor does not start when switched on
Motor hums but does not start when switched on
The motor stops
No detergent
Jet is ineffective, ragged or unsteady
Fuse blows in plug
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycle centre and disposed of in a manner which is compatible with the environment.
When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local
solid waste authority for recycling information.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
REASON
Nozzle incorrect or worn
Dirty filter
Air being sucked into the system
Water pressure low
Worn seals
Nozzle worn or blocked
Water too hot
Pump sucking air
Seals worn
No electrical power
Automatic cut-off system fault
Motor/pump jammed
Unsuitable mains voltage
Pump frozen
Incorrect extension cable
Tripped thermal cut-out due to overheating
Detergent container is empty
Detergent pick up body clogged
Injector clogged
Nozzle not set to low pressure
Incorrect nozzle fitted
High pressure nozzle clogged
Selector sleeve for type of jet wrongly set
Back pressure build up of water causes
machine to draw high amperage
Environmental Protection.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
REMEDY
Replace the nozzle
Clean or replace filter
Check that hoses and fittings are air tight
Check that hoses/fittings are water tight and
tap is fully open
Contact Authorised Service Agent
Replace the nozzle
Reduce temperature
Check that hoses and fittings are air tight
Contact Authorised Service Agent
Check plug connections and mains power
supply is active
Contact Authorised Service Agent
Contact Authorised Service Agent
Check for adequate power supply and cable
condition
Leave unit to thaw naturally. The pressure
washer should be protected from the threat
of freezing. Extensive pump damage could
otherwise occur (see Section 4.6.5)
Use a suitable extension cable. See Section
1 Elect. Safety
Check that the mains voltage matches the
specifications
Switch off the motor and let machine cool for
3 minutes
Refill detergent container
Clear blockage
Clean injector
Move nozzle to low pressure position
Fit correct nozzle (see contents, item 6)
Clean high pressure nozzle
Adjust selector sleeve
Depress trigger before switching on the
machine
www.sealey.co.uk
01284 757500
Web
sales@sealey.co.uk
01284 703534
email
PC3401.V2
Issue: 2 - 01/06/11
Advertisement
