Advertisement
6. TROUBLESHOOTING GUIDE
SYMPTOMS
Pump does not reach required pressure
Fluctuating pressure
Water or oil leaks
Motor does not start when switched on
Motor hums but does not start when switched on
The motor stops
No detergent
Jet is ineffective, ragged or unsteady
Fuse blows in plug
7.
DECLARATION OF CONFORMITY
Declaration of Conformity We, the sole importer into the UK of Sealey Power Products, declare that the product listed below is in
conformity with the following standards and directives.
Pressure Washer - Model PC3401
2006/95/EC Low Voltage Directive
2004/108/EC EMC Directive
2006/42/EC Machinery Directive
2000/14/EC Sound Pressure Directive
2002/95/EC RoHS Directive
2002/96/EC WEEE Directive
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No responsibility is accepted for incorrect use of this equipment.
WARRANTY: Guarantee is 12 months from purchase, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
REASON
Nozzle incorrect or worn
Dirty filter
Air being sucked into the system
Water pressure low
Worn seals
Nozzle worn or blocked
Water too hot
Pump sucking air
Seals worn
No electrical power
Automatic cut-off system fault
Motor/pump jammed
Unsuitable mains voltage
Pump frozen
Incorrect extension cable
Tripped thermal cut-out due to overheating
Detergent container is empty
Detergent pick up body clogged
Injector clogged
Nozzle not set to low pressure
Incorrect nozzle fitted
High pressure nozzle clogged
Selector sleeve for type of jet wrongly set
Back pressure build up of water causes
machine to draw high amperage
The construction files for this product is held by the manufacturer and may
be inspected, by a national authority, upon request to Jack Sealey Ltd.
Signed by Steve Buckle
For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Products.
Sole U.K. Distributor
Sealey Group
Bury St. Edmunds
Suffolk.
REMEDY
Replace the nozzle
Clean or replace filter
Check that hoses and fittings are air tight
Check that hoses/fittings are water tight and
tap is fully open
Contact Authorised Service Agent
Replace the nozzle
Reduce temperature
Check that hoses and fittings are air tight
Contact Authorised Service Agent
Check plug connections and mains power
supply is active
Contact Authorised Service Agent
Contact Authorised Service Agent
Check for adequate power supply and cable
condition
Leave unit to thaw naturally. The pressure
washer should be protected from the threat
of freezing. Extensive pump damage could
otherwise occur (see Section 4.6.5)
Use a suitable extension cable. See Section
1 Elect. Safety
Check that the mains voltage matches the
specifications
Switch off the motor and let machine cool for
3 minutes
Refill detergent container
Clear blockage
Clean injector
Move nozzle to low pressure position
Fit correct nozzle (see contents, item 6)
Clean high pressure nozzle
Adjust selector sleeve
Depress trigger before switching on the
machine
18th July 2008
01284 757500
Web
01284 703534
e-mail
PC3401
www.sealey.co.uk
sales@sealey.co.uk
Issue No: 1 - 18/07/08
Advertisement
