Advertisement
WARNING! Prevent water from penetrating the vents of the pressure washer to minimise the risk of damage to the machine and to
reduce risk of shock to the operator.
6.5
Storage.
6.5.1
Store in a location where the washer will not be subject to freezing conditions.
6.5.2
Make sure that the pressure washer has been drained of water and remove the hoses.
7. TROUBLESHOOTING GUIDE
PROBLEM
Motor will not start or stops during
operation.
Circuit breaker trips or fuse blown
in fuse box.
Water or oil leaking from bottom of
pump.
Trigger will not move.
Unit will not stop when trigger is
released.
Motor running but pump not
reaching maximum pressure or
has irregular pressure.
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to
www.sealey.co.uk, email sales@sealey.co.uk or phone 01284 757500.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
CAUSE
Loose or disconnected plug.
Tripped pressure washer thermal switch.
Power blast trigger not operating properly. Return to Service Agent
Circuit overload.
Extension lead too long or wire size
too small.
Nozzle partially blocked causing
excessive pressure.
A small amount of leakage is normal.
Safety catch engaged.
Auto stop system inoperative.
Water not turned on or partially on.
Unit has been stored in freezing
temperatures.
Water inlet filter clogged.
Kink in supply hose.
Air in pump.
Suction or discharge valves worn out.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
REMEDY
Check plug connections / Reconnect plug
Allow to cool and restart unit.
Check that power supply is correctly rated. Disconnect
other loads from circuit.
Use proper lead as recommended in manual.
Clean nozzle.
If leakage becomes excessive contact service agent.
Release safety catch.
Contact service agent.
Open water tap.
Thaw out unit completely including hose, gun and lance.
Clean filter.
Straighten hose.
Run washer with gun open and lance removed until
a steady stream of water emerges.
Contact Service Agent.
01284 757500
01284 703534
www.sealey.co.uk
Web
sales@sealey.co.uk
email
PC2950.V5
Issue: 2 - 01/06/11
Advertisement
