Table of Contents
Advertisement
6 - Maintenance
Shock absorbers
If the shock absorbers loose their efficiency or start leaking oil, they should be replaced.
Shield renewal on transmission shaft
1. Remove bolt (A), lock (B) and grease nipple (C). Twist uni CV-joint
cover 1/4 turn and pull it backwards.
2. Remove the synthetic bearings and protection tube.
2a. Remove inner bush from protection tube.
3. Assemble again in reverse order, using new parts where necessary.
Remember to fit chains again.
4. Grease bearings.
5. Repeat procedure to the opposite part of the transmission shaft.
ATTENTION! Only use genuine HARDI spare parts to service
the transmission shaft.
Replacement of transmission shaft cross journals.
1. Remove protection guard as described previously.
2. Remove Seeger circlip rings.
3. Press the cross journal sidewards - use hammer and mandrel if
necessary.
4. Remove needle bearing cups and cross journal can now be remo-
ved.
5. Carefully remove needle bearing cups from new cross journal and
install it in reverse order. Before fitting the needle bearing cups
again, check that needles is placed correctly. Avoid dust and dirt in
the new bearings.
6. Repeat procedure to the opposite part of the transmission shaft.
6.22
Advertisement
Table of Contents
