Table of Contents
Advertisement
5
Service Mode
Service Mode > Setting of Bit Switch (SSSW) > Bit Switch Composition > SSSW-SW24
■ SSSW-SW14
● Functional Construction
Bit
Function
0 not used
1 not used
2 direction of scanning for inch/mm
conversion
3 not used
4 inch-configuration resolution declaration
5 not used
6 not used
7 not used
Detailed Discussions of Bit 2
Use it to specify whether to convert or not convert an inch-configuration resolution into a
millimeter-configuration resolution for image read in G3 transmission: either in sub scanning
direction only or in both main and sub scanning directions. The setting is valid only when bit 1
of SW05 of #1 SSSW is set to '1'.
Detailed Discussions of Bit 4
Use it to specify whether to declare or not declare an inch-configuration resolution to the other
machine for G3 communication: if 'declare' is selected, the machine will indicate that it reads
and records at an inch-configuration resolution using the DIS, DCS, or DTC signal.
5
Service Mode > Setting of Bit Switch (SSSW) > Bit Switch Composition > SSSW-SW24
Service Mode
1
0
-
-
-
-
both main and sub
sub scanning
scanning directions
direction only
-
-
declare
do not declare
-
-
-
-
-
-
T-5-12
■ SSSW-SW24
● Functional Construction
Bit
Function
0 PIN CODE function
1 Forced PIN CODE function
2 Forced PIN CODE mode
3 Phone call restriction function
4 Not used
5 Not used
6 Not used
7 Select "ENTER KEY" on program Yes No key menu
Detailed Discussions of Bit 0
When connected to a PBX which has restriction function, set "PIN (Personal Identification
Number) CODE function" to "Yes".
Detailed Discussions of Bit 1
When "Yes" is selected, allows entry of the PIN CODE number even if the PIN CODE button
is not pressed. (When the Bit 0 "PIN CODE function" is set to "Yes", this bit is enables.)
Detailed Discussions of Bit 2
Selects whether the PIN CODE number is entered prior to, or after the telephone number.
When set to "1" the other party's number is sent while dialing, after having sent the PIN
CODE. (When the Bit 1 "Forced PIN CODE function" is set to "Yes", this bit is enabled.)
Detailed Discussions of Bit 3
When "Yes" is selected adds "TEL SETTING" to the RESTRICTIVE CODES menu in the
"SYSTEM SETTING" for the user data program key menu. Depressing the HOOK/OFFHOOK
button for the handset disables the call function for the telephone.
Detailed Discussions of Bit 7
When "Yes" is selected adds "ENTER KEY" to the user data program key menu. To simplify
Transmission Reserve operation, the program key outside the quick-release cover can be set
as the "ENTER KEY".
5-10
1
0
Yes
No
Yes
No
Prefix Suffix
Yes
No
-
-
-
-
-
-
Yes
No
T-5-13
5-10
Advertisement
Table of Contents
