Dual, triple, or quad air pressure gauge (5 pages)
Summary of Contents for Dakota Digital Odyssey II Series
Page 1
Series II ODYR-02-1 & SLX-02-1 rev C PERFORMANCE TACHOMETER MOUNTING: The gauge requires a round hole 3-3/8” in diameter. It should be inserted into the opening from the front and the U-clamp will be installed from the back. Tighten the two nuts on the U-clamp so that the gauge is secure. GAUGE SETUP AND CALIBRATION The setup menus are entered by holding the switch in while turning the key on.
Page 2
The tachometer is adjustable from 1 to 15 cylinder signals and calibration is discussed below. Diesel engines will usually require a diesel tach adapter DSL-1 or DSL-2, available from Dakota Digital, Inc. The bar displays rpm x1000.
Page 3
This gauge can optionally display the gear position for automatic or manual transmissions. For automatic transmissions, Dakota Digital sender GSS-2000 is required. For manual transmissions, this gauge can learn the positions based on speed and rpm when used in conjunction with the ODYR/SLX-01-1, the white wire from ODYR/SLX-01-1 will connect to gray VSS input on the ODYR/SLX-02-1.
Page 4
Any action for breach of any warranty hereunder, including any implied warranty of merchantability, must be brought within a period of 24 months from date of original purchase. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.
This manual is also suitable for:
Odyssey odyr-02-1Odyssey slx-02-1Odyssey slx-02-1 rev c