Checking The Starter Motor - Yamaha WR450FB 2012 Owner's Service Manual

EAS24790

CHECKING THE STARTER MOTOR

1. Check:
• Commutator
Dirt Clean with 600 grit sandpaper.
2. Measure:
• Commutator diameter "a"
Out of specification
motor.
Limit
16.6 mm (0.65 in)
3. Measure:
• Mica undercut "a"
Out of specification
the proper measurement with a hacksaw
blade that has been grounded to fit the com-
mutator.
Mica undercut (depth)
1.50 mm (0.06 in)
TIP
The mica of the commutator must be undercut
to ensure proper operation of the commutator.
4. Measure:
• Armature assembly resistances (commuta-
tor and insulation)
Out of specification
motor.
Replace the starter
Scrape the mica to
Replace the starter
6-33
ELECTRIC STARTER
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Measure the armature assembly resistanc-
es with the pocket tester.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
Armature coil
Commutator resistance "1"
0.0117–0.0143
Insulation resistance "2"
Above 1 M
b. If any resistance is out of specification, re-
place the starter motor.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
5. Measure:
• Brush length "a"
Out of specification
set.
Limit
3.50 mm (0.14 in)
6. Measure:
• Brush spring force
Out of specification
set.
Brush spring force
3.92–5.88 N (400–600 gf, 14.11-
21.17 oz)
Replace the brush
Replace the brush