Husqvarna 570 Workshop Manual page 52

5. Use tool 502 50 30-20. Turn around the sleeve (B)
and pull on the flywheel sideʼs crankcase half. Pull
until the gasket is clamped between the crankcase
halves. See fig. 12.
6. Fit the six bolts. Tighten them alternately. Tighten
them finally to 8 Nm. See fig. 13.
NOTE!
Make sure that excess gasket material does
not fall into the crankcase.
7. Cut off the gasket at the level of the cylinder base.
8. Fit the carburettor space bottom with the four bolts.
Tighten the bolts to 5 Nm.
9. Assemble the following parts:
A. Tank unit. See page 41.
B. Piston and cylinder. See page 45.
C. Muffler. See page 15.
D. Carburettor. See page 35.
E. Lubrication system. See page 29.
F. Centrifugal clutch. See page 27.
G. Electrical system. See page 21.
H. Starter. See page 19.
I. Chain and bar. See the Operator's Manual.
10.If a new crankshaft is fitted the chainsaw should be
run-in for 3-4 hours. See adjustment of the carburettor
on page 38 and 39.
52 – English
CRANKCASE and CRANKSHAFT
B
Fig. 12
Fig. 13