Husqvarna 570 Workshop Manual page 47

11. Fit the filterholder with choke on carburettor. Use
long screws (L) on the upper part and short screws
(M) on lower part. See fig. 14.
12. Fit carburettor with filter holder on manifold.
• Fit choke shaft (P) in notch.
• Slide choke rod (N) in guide (O).
• Push in the choke rod (Q).
• The impuls nipple should meet the impuls hose
(R).
• Tighten the screws
• Connect the rear rubber mount (S). See fig. 15.
13. Assemble the following parts:
• Muffler. See page 15.
• Cylinder cover. See the Operator's Manual.
• Chain and bar. See the Operator's Manual.
14. If a new piston and/or cylinder is fitted the chainsaw
should be run-in for 3-4 hours. See carburettor
settings on pages 38
PISTON and CYLINDER
2 Nm.
and 39.
Fig. 14
N
O
Fig. 15
Lx2
Mx2
R
Q
P
English – 47