Table of Contents
Advertisement
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen the
coupling.
2. Push and hold the button (C).
3. Hold tight in the end of the shaft that the motor is
attached to.
4. Pull the attachment out of the coupling.
C
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING: Use protective gloves.
WARNING: Always use the cutting
attachment guard that is recommended for
the cutting attachment. See
on page 17 .
WARNING: An incorrectly attached cutting
attachment can result in injury or death.
785 - 001 - 04.12.2019
To install the suspension ring if applicable
1. Install the suspension ring between the arrows on
2. Adjust the ring to make the product balanced, and
Assembly of trimmer heads
To attach the trimmer guard for a trimmer
head
1. Hang the trimmer guard (A) onto the two hooks on
2. Bend the guard around the shaft and attach it with
3. Put the locking pin (C) in the groove on the bolt head
Technical data
To attach a trimmer head
1. Put the drive disc (B) on the output shaft.
the rear handle and the loop handle.
Note: Do not put the loop handle on the decal.
easy to use.
WARNING: When you install the cutting
attachment it is very important that the
raised section on the drive disc/support
flange engages correctly in the centre hole
of the cutting attachment. If the cutting
attachment is install incorrectly it can result
in serious and/or fatal personal injury.
WARNING: Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard, or the J-handle is missing when using
metallic cutting attachment, is fitted this can
cause serious personal injury.
the plate holder (M).
the bolt (L) on the opposite side of the shaft.
and tighten the bolt fully.
M
A
L
C
11
Advertisement
Table of Contents
