Steps
1. Slide the touchpad into the slot on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x2) that secure the touchpad to the palm-rest and keyboard assembly.
3. Adhere the tape that secures the touchpad to the palm-rest and keyboard assembly.
4. Slide the touchpad cable into the connector on the touchpad and close the latch to secure the cable.
5. Place the touchpad bracket into the slot on the palm-rest and keyboard assembly.
6. Replace the three screws (M2x2) that secure the touchpad bracket to the palm-rest and keyboard assembly.
7. Adhere the tape that secures the speaker cable to the touchpad bracket.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Follow the procedure in
Pen-garage cable
Removing the pen-garage cable
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
The following image indicates the location of the pen-garage cable and provides a visual representation of the removal procedure.
After working inside your
computer.
Before working inside your
computer.
Removing and installing components
29