Using A Password - Franklin MWD-460 User Manual

To Erase All the Phone List Entries
Warning! This procedure permanently erases all the names and numbers in your phone list.
1. Press DATA.
2. Press or
3. Press Y to erase all the entries or N to cancel the operation.
You can use a password to keep the information in the phone list private. The password is requested
when the unit is turned on and the phone list is accessed.
Password Warnings
Warning! After you set the password, you must enter the password to access the phone list for the
first time during a session. Always record your password and keep it in a separate place.
If you forget the password, you must reset the unit to access the phone list. Warning! Resetting the
unit erases all user-entered information. Always keep written copies of your data.
If you do not have a reset button located on the back of your unit, remove the batteries, wait at least
two minutes, and then re-install them. For battery instructions, see "Replacing Batteries".
If you have a reset button, use the end of a straightened paper clip to gently press the reset button.
If the unit does not reset after pressing the reset button, follow the above instructions for removing
the batteries.
to highlight Erase All Data and then press ENTER.

Using a Password