Frontgate Holiday 33027 Manual

7.5' FRASER FIR TREE - ITEM #33027

PARTS LIST

A. TOP
B. MIDDLE
C. BOTTOM
HARDWARE
A. TREE STAND
B. 1/4" SCREWS FOR TREE STAND
C. POWER STRIP
D. REMOTE CONTROL W/ RECEIVER
E. PINE CONE ORNAMENT
Step 1
Pull apart the legs of the stand so that they are "X" shaped.
Fasten the bottom screws to lock the stand into position.
Step 2
Insert the section (C) of the tree into the stand and tighten
screws on base to secure tree pole.
Step 3
Plug light set of (C) into power strip, plug power strip into
remote control receiver. Then, plug remote control receiver
into wall outlet.
Step 4
To shape your tree, start with the bottom most layer of
branches, with each branch start with the tips closest to the
pole and lift each tip up and out in alternating directions.
Repeat for each branch. It is recommended to shape section
(C) before adding section (B).
Step 5
Insert the section (B) of the tree into the section (C) of the
tree. Plug light set of (B) into power strip and repeat steps 4
and 5 for shaping.
Step 6
Insert the section (A) of the tree into the section (B) of the
tree. Plug light set of (A) into the section (B).
Step 7
To shape the top of the tree it will be necessary to gently bend
the branches downward to the desired angle before shaping
the tips.
NUMBER OF PERSONS
RECOMMENDED FOR
ASSEMBLY: 2
QUANTITY 1 PC
QUANTITY 5 PCS
QUANTITY 1 PC
QUANTITY 1 SET
QUANTITY 2 PCS

ASSEMBLY INSTRUCTIONS

R
and
PLUG-IN REMOTE
CONTROL RECEIVER
EMOTE CONTROL
Wall Outlet
Drawing not to Scale
SKU 33027 - 7.5' FRASER FIR TREE
5794 TIPS
METAL STAND
UL 1200 LIGHTS
MAX DIAMETER 63"
T A
OP SECTION
M B
IDDLE SECTION
B
OTTOM SECTION
L X
EGS SET IN SHAPE
C