Idler Assembly - Toro Greensmaster Flex 1018 Service Manual

Idler Assembly

g285713
1. Socket-head screw (2 each)
2. Bolt
3. Motor adapter
4. Bushing
5. Idler arm
6. O-ring
Removing the Idler Assembly
Installing the Idler Assembly
Greensmaster ® Flex 1018/1021
20247SL Rev A
7. Lock nut (2 each)
8. Shield
9. Stub shaft
10. Flocked seal (2 each)
11. Bearing
12. Retaining ring
Note: The groomer idler assembly is located on the opposite side of the groomer
gearbox assembly.
1. Remove the reel drive from the cutting unit; refer to
Assembly (page 8–14).
2. Remove the groomer reel assembly; refer to
(page 9–15).
3. Remove the cotter pin and clevis pin from the height adjustment rod at the
front of the idler arm. Discard the cotter pin.
4. Remove the two socket-head screws that secure the motor adapter to the
cutting unit, and remove the adapter and idler assembly. Retrieve and
discard the O-ring and lock nuts.
5. Inspect the shields, bearing, and bushing in the idler assembly. Remove and
discard the components that are worn or damaged.
1. If the shields, bearing, or bushing was removed from the idler arm, install
new components as follows:
A. Press the bushing into a groomer plate until the bushing is centered in
the idler arm bore.
B. Press the bearing into the idler arm so that the bearing contacts the
shoulder in idler arm bore and install the bearing retaining ring.
Figure 95
13.
14.
15.
16.
Page 9–13 Universal Groomer (Optional): Service and Repairs
Flange nut
Clevis pin
Cotter pin
Collar
Removing the Reel
Removing the Groomer Reel