Ebyte E810 Series User Manual page 18

E810-DTU wireless transceiver E810 series user manual
Figure 20 Data transparent transmission
7.2.3 UDP Server instructions
(1) Connect two E810-DTU serial ports and network cables to PC, open the network configuration software and search
for the device. The searched device will display the device list. Double-click the device to be configured in the list and enter
the setting interface. Set the module to UDP Server mode, set the target IP address to 192.168.3.100, set the target port of
module A to 8887, the target port of module B to 8886, set the RF parameters, click the OK button after the setting is
complete, and then restart the device to search Check once to see if the parameter modification was successful.
Figure 21 Searching devices
17
Chengdu Ebyte Electronic Technology Co., Ltd.