E810-DTU wireless transceiver
E810 series user manual
7. Quick instructions
7.1 Parameter setting instructions
Figure 12 Parameter setting instructions
7.2 Socket instructions
7.2.1 TCP Server instructions
(1) Connect two E810-DTU cable to the PC. Open the network configuration software and search for the device. The
searched device will be displayed in the device list. Double-click the device to be configured in the list, enter the setting
interface, and set the module to TCP Server mode, Set the module IP address to 192.168.4.101, 192.168.4.102, set the
module's local port to 8886, set the RF parameters. After the setting is complete, click the OK button, then restart the device
and search again to see if the parameter modification was successful.
12
Chengdu Ebyte Electronic Technology Co., Ltd.