Advertisement
network), the Gateway was unable to receive a val-
id IP address from the network. However, the Yel-
low LED will still turn on solid and the Green
LED will still flicker. Do not confuse this with the
above valid IP address indication.
Refer to the flowchart for a visual representation of the
above process:
Next, reset the Gateway as follows:
Reset the Gateway
IMPORTANT: Before securing the Gateway hous-
ing cover, ALWAYS reset the Gateway memory, even
if the Gateway is new "out of the box" and/or has nev-
er been used previously.
After initial power up, press and hold the RESET but-
ton (see below for location); continue to hold the but-
ton until the red LED turns on solid. Now, release the
button and the green LED will flicker rapidly.
Always reset the Gateway for new installations; you
can also reset the Gateway any time after the Gate-
way is powered. Two levels of reset exist, a "Normal"
reset and "Factory" reset, as follows:
Normal Reset: Clears Gateway memory and user
data allowing for re-discovery by DL-Windows. Press
and hold the RESET button until the Red LED turns
on solid, then release the button and the Green LED
will start to flicker rapidly.
Factory Reset: Clears Gateway memory, user data
and configuration data (such as static IP information),
thus returning the unit to its original factory settings.
Press and hold the RESET button, the Red LED turns
on solid; keep holding until the Yellow LED also turns
on solid. Release the button; the Yellow LED will re-
main on solid, and the Green LED will start to flicker
rapidly, indicating a full factory reset.
Note: Resetting the Gateway (Normal or Factory)
does NOT cause the Gateway to search for a new IP
address. After a reset, power cycle the Gateway to
initiate a new IP search.
GATEWAY LED INDICATIONS
Receiver On (normal operation)
Yellow
Transmitter On
Red
Not configured - Rapid blinking / flickering
Idle / configured - 1 blink per second
Green
Lock Communication Fail - 2 blinks
(continuously)
Expander Communication Fail - 4 blinks
(continuously)
CLOSE HOUSING COVER
Close the housing cover by first engaging the hooks at
the top, then snapping the bottom together. Secure
the cover with the Bottom Screw provided as shown in
Fig. 6.
Fig. 6: Bottom Screw
Congratulations! You're finished! Now go to the
DL-WINDOWS™ for Networx™ V5 USER'S GUIDE
(OI383) for instructions about discovering your Gate-
way from DL-Windows.
(Gateway Status)
5
Advertisement
