Hitachi DS55MU01 User Manual page 55

DS55MU01
Some picture elements do not light
up
After-Images can still be seen
on the display after the display
is powered off. (Examples of still
pictures include logos, video games,
computer images, and images
displayed in 4:3 normal mode)
How to setup the settings in the
menu to control all the monitors at
the same time and individually via
RC?
How is the RC working?
Some pixels of the display may not
turn on.
A still picture is displayed for an over
extended period of time
Daisy chained by RS232 and no IR
cable
Daisy chain : no RS232 connected
and IR cable
48
This display is manufactured using
an extremely high level of precision
technology: however, sometimes some
pixels of the display may not display.
This is not a malfunction.
Do not allow a still image to be
displayed for an extended period of
time as this can cause a permanent
after-image to remain on the display.
1. The first display sets as "Primary"
on OSD (Advanced option/IR control
item), others set as "Secondary".
2. The setup OSD will show on Top-
Left of display.(Toggle MENU will show
again if it disappear)
3. Default setting: ID NO: 0, GP NO: 0,
this setting can control all displays by
IR.
The "+", "-" can change "ID NO" to
control signal display by "Monitor ID".
The "UP", "DOWN" can change "GP
NO" to control multi-display by "Group
ID".
*The first display always be
controlled by IR.
No need setting, just to connect with
IR cables and control by IR.
*This way has out-of-synchronizm
phenomenon. Suggest to use above
setting with RS-232 cable.