Set Point Display; Internal Light - Foster Slim 700 NG Original Instructions Manual

English
Function Icons and Buttons/ Switches
Manual Defrost/ Decrease Button
Alarms/ Warnings
Unit Low Temperature Alarm
Unit High Temperature Alarm
High pressure alarm (Mains lights will go off).
Controller in Standy-by
Keypad Locked

Set Point Display

Press button briefly (at least half a second) to display the set point.
Keypad Security Settings
Press & release then select
seconds or briefly press

Internal Light

When pressed and released this button will switch on and off the display lights, with the unit running or in
standby mode. If the lights do not come on this may be due to a fault warning, please see the troubleshooting
section for more details.
Shelves and Supports
On delivery of the Multideck these parts are supplied wrapped inside the unit on the base shelf. These will
require cleaning and fitting at first install.
Supports can be fitted at three different angles, allowing the
shelf to be tilted or level. Each shelf requires two supports
(unless on a 1500 or 1800 model then a third centre support is
also required).
Slot the first support into one side of the ladderacking at the
height and angle the shelf will be required. Repeat this on the
opposite side at the same position and angle (do the same for
the centre support if applicable).
Always remember that you will need to allow for breathing
space around, not only the shelves, but the product. Remember to leave enough space between the supports
when positioning on the ladderack.
3
Info/Set Point Button
Compressor Output
Fan Output
Light Output
to show 'LOC'. Press and hold
to resume to normal operation.
Increase Button/ Lights On/Off
Exit/ Standby Button
Alarm
Defrost Output
T1 Air probe failure
T2 Evaporator probe failure
T3 Product probe failure
Defrost in progress
to change from 'YES' to 'NO'. Leave for 10