Table of Contents
Advertisement
BACKPACKING
34
35
Your treestand is designed to "nest" together as one
unit making it easy to transport.
1. Un-buckle the backpack strap tether from the seat
frame yolk and Re-buckle it around the perimeter
tubing of the platform. This step should disconnect
your seat climber from your platform.
2. Start with the seat climber portion of the stand, set
it on its end as shown in figure 34.
3. Take the platform and slide it into the seat climber
so that its upright braces and cable bracket are next
to the same areas on the seat climber as shown in
figure 35.
4. The teeth area on the platform should come into
contact with the "V" brace on the seat climber. From
this position, pull the seat backrest through the large
gap in the platform.
5. Secure the seat to the stand by running the seat
bungee around the frame and clipping it off.
36
6. If your backpack straps are connected to
the platform, the straps will most likely be
wedged in behind the seat. Pull them out and
around the seat webbing and push the seat as
37
far down in the frame as possible (see figure
36).
7. Secure the top and platform together with
the 1" wide green strap with the spring loaded
tourniquet buckle as shown in figure 37. This
will prevent seat the seat and the platform
from making noise as you hike to your hunting
location.
8. Use the backpack straps to carry the unit
on your back as shown in figure 38. Pull the
loose end of the straps to tighten and pull up
on the buckle to release.
38
PG 9
Advertisement
Table of Contents
