Laserworld Club Series Manual page 11

Manual: CS-1000RGB
• ILDA control: Connect your device („ILDA IN") via an ILDA cable to an inter-
face / controller. Use a laser control software, to run the device. Use „ILDA
OUT" to connect it to another device. In ILDA mode all DIP switches should
be switched off.
• Master-Slave-Mode: To use the daisy chain / Master-Slave-Mode connect
two (or more) laser projectors of the same series via DMX cables:
Master projector (DMX out) -> DMX cable -> slave projector 1 (DMX in) ;
slave projector 1 (DMX out) -> DMX cable -> slave projector 2 ...etc.
Master projector
Choose stand-alone or
sound-to-lightmode at
the master projector
(see above)
6. To turn off the device switch it off („OFF"), switch the key to „OFF" and discon-
nect the power cable from the mains.
7. Close the beam block shutter to prevent laser output: Loose both screws and
slide the shutter in front of the window. Tighten the screws again. Do it con-
versely to open the beam block shutter.
DMX cable
Slave projector
DMX setting at the slave
projector:
page 10 / 11 EN