Table of Contents
Advertisement
Installation and Configuration
Installation and Configuration
Caution on Installation
Place the projector in a well-ventilated environment.
ꔈ To prevent internal heat build-up, install the projector in a
well-ventilated place. Do not place anything near the projec-
tor as this may block its air vents. If the air vents are
blocked, the internal temperature will increase.
ꔈ Be sure to prevent foreign objects such as paper debris from
entering the projector.
Do not place the projector in a hot or humid environment.
ꔈ Only install the projector in a place of moderate temperature and low humidity.
(See page 57 regarding operating temperature and humidity.)
Do not place the projector in a place where it will easily collect dust.
ꔈ There is risk of fire.
Do not remove any covers except for the lens cap. There is a high risk of electric shock.
The projector is manufactured using high-precision technology. You may, however, see tiny black dots and/or bright col-
ored dots (red, blue or green) that continuously appear on the projector screen. This is a normal result of the manufactur-
ing process and does not indicate a malfunction.
The remote control may not work in an environment where a lamp equipped with electronic ballasts or a three-wave-
length fluorescent lamp is installed.
Replace the lamp with an internationally standardized lamp for the remote control to work normally.
14
ꔈ Do not place the projector on a carpet or rug. This may pre-
vent proper ventilation at the bottom of the projector. This
product should be mounted onto a flat surface or ceiling
only.
ꔈ Leave an adequate distance (30 cm or more) around the
projector.
Advertisement
Table of Contents
