Display Assembly - HP 340S G7 Maintenance And Service Manual

Display assembly

NOTE: Display assemblies are offered as spare parts only at a subcomponent level.
Before removing the display assembly, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the power button/card reader board (see
Remove the display assembly:
1. Disconnect the display cable from the system board (1), and then remove the cable from the clips in the
right hinge (2).
2. Disconnect the wireless antenna cables from the WLAN module (3), and then remove the cables from
the channel and clips in the left speaker (4).
3. Open the display (1).
4. Remove the two Phillips M2.5 × 5.0 screws (2) from each hinge.
(Preparation for disassembly on page
Bottom cover on page
Battery on page 27).
25).
Power button/card reader board on page
Component replacement procedures
24).
33).
43