Download Print this page

Dimplex Desk Friend DDF250 Installation And Operating Instructions page 3

Ceramic fan heater

Advertisement

NOTE: The fuse cover of a non-rewirable plug must be
refitted when changing the fuse. Should the cover become
lost, the plug must not be used until the correct replacement
fuse cover is obtained from your supplier or by contacting
our customer helpline.
IMPORTANT: The wires in this mains lead are coloured in
accordance with the following code:
BLUE:
BROWN:
As the colours of the wires in the mains lead may not
correspond with the coloured markings in your plug, proceed
as follows:
Connect the BROWN wire to the terminal marked 'L' or
coloured RED. Connect the BLUE wire to the terminal
marked 'N' or coloured BLACK. Note: 'L' or 'N' must not
be connected to the EARTH terminal marked 'E' or ' ' or
coloured GREEN or GREEN AND YELLOW.
If in doubt, consult your electrician.
Using the Heater
Main Elements
- See Fig 1.
1.
Power indicator light
2.
Standby thermostat
3.
Air outlet grille
4.
USB charge port
5.
Safety tilt switch
Standby Thermostat - see Fig. 2
The heat output is controlled by the
thermostat, according to the local
area temperature.
Turn the thermostat knob fully
clockwise to maximum setting
initially. When the area is warm
enough, reduce the setting slowly
Fig. 2
until the heater just clicks off.
The heater will now cycle on and off to maintain your local
area temperature. An audible click may be heard when the
thermostat operates - this is normal.
Note: If the heater does not come on when the thermostat
is at a low setting, this is normally because the local area
is warmer than the thermostat setting and is not a fault.
Position ' ' will put the heater into standby mode (unless
the temperature is approximately 5°C). This is a special
setting to enable the product to be used as a charger
throughout the year.
Safety - Overheat Protection and Tilt Switch
For your safety, this appliance is fitted with a thermal cut-out.
In the event that the product overheats, the cut-out switches
the heater off automatically. To bring the heater back into
operation, remove the cause of overheating, then turn off
the electrical supply to the heater for a few minutes.
When the heater has cooled sufficiently reconnect and
switch on the heater.
If the cut-out operates repeatedly, contact your supplier.
The heater is also fitted with a tilt switch, so in the event
the heater gets accidentally knocked over the product will
not operate.
NEUTRAL
LIVE
USB Charge Port
This product also has the facility of a USB charge port which
supplies a 5V 2.1A supply. Please ensure that your device
is suitable before connecting to the USB port. It is designed
to charge the majority of tablets and smartphones.
Cleaning
WARNING ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE CLEANING THE HEATER.
Do not use detergents, abrasive cleaning powders or polish
of any kind on the heater.
Wipe with a dry cloth to remove dust and a damp cloth (not
wet) to clean off stains. Be careful not to allow moisture
into the heater.
Ensure that dust or fluff does not accumulate inside the
heater as this could lead to overheating of the element.
Use a vacuum cleaner to remove any fluff which does
accumulate.
Recycling
This marking indicates that this product
should not be disposed with other household
wastes throughout the EU. To prevent possible
harm to the environment or human health
from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse
of material resources. To return your used device, please
use the return and collection systems or contact the retailer
where the product was purchased. They can take this
product for environmental safe recycling.
Model Identifier(s):
Heat output
Nominal heat output
Minimum heat output (indicative)
Maximum continuous heat output
Auxiliary electricity Consumption
At nominal heat output
At minimum heat output
In standby mode
Type of heat output/ room temperature control
Mechanical thermostat room temperature control
Contact details
DDF250
Pnom
0.25
Pmin
0.25
Pmax,c
0.25
elmax
0.0
elmin
0.0
elSB
0.0
GDHV
Millbrook House, Grange Drive, Hedge
End, Southampton.
SO30 2DF
kW
kW
kW
kW
kW
kW
Yes

Advertisement

loading

This manual is also suitable for:

Desk friend ddf250b