Hitachi Compute Rack 220S Replacement Manual page 49

Installing the rear top cover
NOTICE
1. Align the hooks inside the rear top cover side tabs with the guide slots on both
sides of the chassis.
2. Close and slide the rear top cover toward the center of the system unit.
3. Tighten the two captive screws at the rear of the system unit.
3
Figure 3-7: Install the rear top cover
4. Reinstall the system unit to the rack cabinet.
See Sliding the system unit into a rack cabinet
Make sure all of the internal cables and components are correctly kept
inside the system unit before installing the cover. Otherwise, the
cables may be damaged or disconnected.
1
Hitachi Compute Rack 220S CRU Replacement Guide
2
3
Preparation
on page 3-6.
3-9