Propulsion System Technical Information - Master Spas MP Swim Spa Owner's Manual

PROPULSION SYSTEM
TECHNICAL INFORMATION
CRITICAL REPLACEMENT COMPONENT PART NUMBERS:
WARNING: Items listed below shall only be replaced with identical components unless approved
by Master Spas Engineering Department. Any change or alteration to the system components will
cause a safety hazard and void the safety certification.
PROPULSION SUCTION GRATES MISC. SPECIFICATIONS:
• Wall mount only
• Life span 7 years
• Tools required – No. 2 Phillips screwdriver
• Pulley system shall be 1:1 ratio only
NOTE: Fittings and fasteners should be observed for damage or tampering before each use of the
swim spa.
• Propulsion suction grate assembly: X804490
• Propeller
- Wave XP ............X400820
- Wave XP PRO .....X400820
• *Max. Frequency
- Wave XP ............60Hz.
- Wave XP PRO .....68Hz.
*This is the certified maximum frequency. Actual frequency setting may vary.
NOTE: The propulsion system is designed to operate at any speed (Swim Number 1-100) for 30
minutes. The propulsion system can be operated for as much as 60 minutes continuous as long as the
Swim Number is limited to 90 or below. If Swim Number exceeds 90 for more than 30 minutes, the
propulsion motor could shut down to protect itself or trip the internal GFCI breaker. This is considered
normal and can be avoided by operating the system as described above. If the system shuts down,
verify that the internal GFCI is reset (on), allow time for the motor to cool, then operate as normal.
DO NOT DIVE. DO NOT DIVE.
• Propulsion grate fasteners (4 per grate): X717900
111 98