Advertisement
Available languages
Available languages
Quick Links
IMPORTANT:
SAVE FOR LOCAL ELECTRICAL INSPECTOR'S
USE.
READ AND SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE,
OBSERVE ALL GOVERNING
CODES AND ORDINANCES.
If the information
in this manual
is not followed
exactly,
a fire or explosion
may result
causing property
damage,
personal
injury
or death.
FOR YOUR SAFETY:
m
Do not store or use gasoline
or other
flammable
vapors
and liquids in the vicinity
of this or
any other appliance,
WHAT
TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance,
•
Do not touch any electrical
switch; do not use any phone in your building,
•
Immediately
call your gas supplier
from a neighbor's
phone.
Follow
the gas supplier's
instructions,
•
If you cannot
reach your gas supplier,
call the fire department,
Installation
and service must be performed
by a qualified
installer,
service agency or the gas
supplier.
40 1/8" Min.
101.9 cm Min.)
Min.
(45.7
cm Min.)
(33 cm Min.)
Grounded
24" Min.
Wall Outlet
(61 cm Min.)
24 1/2" Max.
(62.2 cm Max.)
Do not pinch the power supply cord between the range
and the wall.
"9"28
1/8" (71.4 cm) with
handle
1
36" (91.4 cm)
with
feet
extended
NOTE: 24" (61 cm) minimum
clearance between the
cooktop and the bottom of the cabinet when the bottom
of wood or metal cabinet is protected by not less than
1/4" (0.64 cm) flame retardant millboard covered with not
less than No. 28 MSG sheet metal, 0.015"
(0.4 mm)
stainless steel, 0.024" (0.6 mm) aluminum, or 0.020" (0.5
mm) copper.
30" (76.2 cm) minimum clearance when the cabinet is
Do not seal the range to the side cabinets,
unprotected.
463/4"(118.7cm)
401/8"(101.9cm)
257/8"(65.7cm)
433/4"(111.1 cm)
401/4"(102.2cm)
36" (91.4 cm) standard
35 3/8" (90 cm) rain.
P/N 318201752 (0201) Rev. C
English - pages 1-11
EspaSol - p_iginas 12-22
Wiring Diagram - page 23
Advertisement
Related Manuals for Kenmore 79074503990
Summary of Contents for Kenmore 79074503990
- Page 1 IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE, OBSERVE ALL GOVERNING CODES AND ORDINANCES. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.
-
Page 2: Important Safety Instructions
standard is not applicable, the Standard for Important Notes to the Installer Manufactured Home Installation 1982 (Manufactured Read all instructions contained in these installation Home Sites, Communities and Setups), ANSI Z225.1/ instructions before installing range. NFPA 501A-latest edition, or with local codes. Remove all packing material from the oven = Make sure the wall coverings around the range compartments before connecting the electrical supply... - Page 3 Power Supply Cord Kit Electrical Connection to the Range The user is responsible for connecting the power supply This appliance is manufactured with the neutral terminal cord to the connection block located behind the back connected to the range. panel access cover. While connecting range, do not This appliance may be connected by means of loosen the nuts which secure the terminal...
- Page 4 2. Remove the 3 loose nuts (after you removed the 6. Replace the 3 nuts on the terminal block (see fig. 4). rubber band) on the terminal block using 3/8" nut 7. Lower the terminal cover and replace the 3 screws. driver or socket.
- Page 5 Cable from Junction Box Location Residence White Wire Locate junction box as shown in Figure 7. (Neutral) If a service cord is used, the wall receptacle should be located in accordance with the dimensions below. Wires- Center Line of Range 20"...
- Page 6 the cabinet. I f back of range will not be flush with The supply line should be equipped with an approved the wall (the location of the outlet may not allow the shutoff valve (see Figure 9). This valve should be located range to be positioned against the wall), draw a line on in the same room as the range and should be in a the floor where the back edge of the range will be.
- Page 7 Tighten all connections if necessary to prevent gas Moving Appliance leakage in the cooktop or supply line. Servicing and Cleaning Turn off the range line fuse or circuit breakers at the Check alignment of valves after connecting the main power source, and turn off the manual gas shut-off cooktop to the gas supply to be sure the manifold pipe valve.
- Page 8 Slide range into cut-out opening and double check Range Installation for levelness. If the range is not level, pull unit out [Ir_'_TJ'i_J'_ When unpacking the range, do not and readjust leveling legs, or make sure floor is discard the 4 shipping bolts. These are to be replaced on level.
- Page 9 Turn on Electrical Power and Open Main Shutoff Operation of Oven Elements Gas Valve The oven is equipped with an electronic oven control. Each of the functions has been factory checked before shipping. Check the Igniters However, it is suggested that you verify the operation of Operation of electric igniters should be checked after the electronic oven controls once more.
- Page 10 Unfold paper template and place it flat on the floor Important Safety Warning with the back and side edges positioned exactly To reduce the risk of tipping of the range, the range where the back and sides of range will be located must be secured to the floor by properly installed anti-tip when installed.
- Page 11 NOTES:...
- Page 12 IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS INSTRUCCIONES PARA REFERENCIA FUTURA. OBSERVE CODIGOS TODO GOBERNANTES Y ORDENANZAS. riT_J_m_lsi la informacion contenida en este manual no es seguida exactamente, puede ocurrir un incendio o explosion causando da6os materiales,...
-
Page 13: Nota Importante
• La instalaci6n de aparatos dise_ados para instalaci6n Notas importantes para el Instalador en casas prefabricadas (m6viles) debe conformar Lea todas las instrucciones contenidas en este manual el Manufactured Home Construction and Safety antes de instalar la estufa. Standard, t[tulo 24CFR, parte 3280 [Anteriormente Saque todo el material... - Page 14 • No almacene ni utilice gasolina u otros vapores r13[_'_"=_'_ AI realizar la conexi6n de la estufa, no liquidos inflamables en la proximidad de dste o desaprete las tuercas que aseguran el alambraje de la estufa al de cualquier otro artefacto eldctrico.
- Page 15 5. Conecte el alambre neutro (blanco) del cord6n 1. Quite los tres tornillos en la parte m_s baja del panel el_ctrico de cobre al terminal de color de plata en el trasero, luego levante la parte m_s baja del panel centro del bloque y conecte...
- Page 16 En el cortacircuito, la caja de fusibles o la caja de Situacibn de caja de unibn empalmes a) Conecte el alambre verde (o cobre desnudo), de la estufa alambre blanco del cable del el_ctrodom_stico y el alambre neutral (blanco)juntos. b) Conecte los dos alambres negros juntos. .4 crn) 4_510"...
- Page 17 Abra la v_lvula de cierre en la I[nea de suministro Si la estufa no serd instalada junta contra un armario, mueva la estufa a su posici6n final. Marque el piso por los gas. Espere unos minutos a que el gas se mueva por el tubo.
- Page 18 Desconecte esta estufa y su v&lvula individual La mudanza del aparato para reparaciones cierre del sistema del siministro de gas durante limpieza cualquier prueba de presi6n de ese sistema a presiones Apague la corriente el_ctrica a la estufa a la fuente de mayores de 1/2 psig (3.5 kPa o 14"...
- Page 19 Instalacibn de la estufa 2. Ponga un nivel sobre la parrilla. Tome dos lecturas con el nivel puesto diagonalmente en una direcci6n Mientras se desembala la estufa, despu_s en la otra. Nivele la estufa, si es necesario, deseche los cuatro (4) pernos de embabalaje.
- Page 20 Funcionamiento de los Elementos del Horno Enciende la corriente eldctrica y abre la vdlvula principal de cierre. El horno est_ equipado con un control electr6nico. Cada funci6n ha sido probada en la f_brica antes del transporte. Comprobacion de los Encendedores Sin embargo, sugerimos que Ud.
- Page 21 Desdoble la plantilla de papel y col6quela plana en Importante Advertencia de Seguridad el piso con los bordes laterales y el trasero colocados Para reducir el riesgo de que la estufa se vuelque, exactamente donde la parte trasera y los lados de la necesario asegurarla al piso instalando los soportes...
- Page 22 NOTAS:...
- Page 23 COOKTOP CIRCU]T OVEN CIRCUIT TOP BURNER IGNITER CIRCUITO DE HORNO PLANCHA DE COCINAR OUEHA(]OR DE ENCEN(]IDO SUPERIOR IGN. SW. I_:%c. I DOOR LATCH SWITCH INT. DE CERROJO DE PUERTA TRASERO SW.A THERMAL CIRCUIT BREAKER "-_--U___ INTERRUPTOR DE CIRCUIT(] TERBIC(] T(]P BURNER IGNITER (]UEMADOR DE ENCENDIO(] SUPERIOR CONTROLDE HORNOELECTRONICO...