Advertisement
Simplicity on the Worksite
Using ON/OFF Control
Step 2 Setting ON/OFF Control Parameters
1
Setting ON/OFF Control
You set this parameter in the Initial Setting Level. The parameter is set to ON/OFF control by default.
1
Turn ON the power supply.
2
Press the
Key for at least 3 seconds.
Press the
(Level) Key for
at least 3
seconds.
3
Change the parameter with the
Press the
several times to display
cntl(CNTL).
2
Setting Direct or Reverse Operation
You set this parameter in the Initial Setting Level. The parameter is set to reverse operation by
default.
1
Change the parameter with the
Press the
several times to display
orev (OREV).
Change the set value with the
(When finished, press the
to the operation display.)
2-2
Solutions Guide for FAQs: E5@N
Operating Display
←Flashes 3 times.
Key.
Initial Setting Level
(Mode) Key
Key.
Initial Setting Level
(Mode) Key
(Up and Down) Keys.
(Level) Key for at least 1 second to return
Initial Setting Level
←in-t (IN-T) will be displayed to
show that the Initial Setting Level
has been entered.
←cntl(CNTL): Indicates the Control Method
parameter.
←Default setting is onof (ONOF): ON/OFF
control.
If pid (PID control) is displayed, press
the
(Down) Key to change to onof
(ONOF) (ON/OFF control).
←orev (OREV): Indicates the
Direct/Reverse Operation parameter.
←Default setting is or-r (OR-R):
Direct operation.
or-r (OR-R): Reverse operation (default)
or-d (OR-D): Direct operation
Advertisement
