Example - Ipoa Or Eoa; Example - Dhcp - Fortinet FortiGate FortiGate-60 Install Manual

Configuring the ADSL interface
FortiGate-60ADSL FortiOS 3.0 MR6 Install Guide
01-30006-0448-20080131
pppoe-unnumbered-
negotiate
{disable | enable}
status {down | up}
username
<pppoe_username>
vci <integer>
vpi <integer>

Example - IPOA or EOA

This example shows the settings required to use an IP address of 10.10.10.1 and
a netmask of 255.255.255.0 with IPOA using PPPoE and custom VPI and VCI
settings. This example also applies to the EOA mode if you change the mode
setting to eoa.
config system interface
edit adsl
set mode ipoa
set ip 10.10.10.1 255.255.255.0
set vpi 1
set vci 34
set mux-type llc-encaps
set connection enable
end
end

Example - DHCP

This example shows the settings required to connect to an ISP using DHCP with
default VCI and VPI settings.
config system interface
edit adsl
set mode dhcp
set mux-type llc-encaps
set connection enable
end
end
Configuring the ADSL interface using the CLI
Disable to resolve problems when mode
is set to PPPoE, and ipunnumbered is
set. The default configuration may not
work in some regions, such as Japan.
This is only available when mode is
pppoe and ipunnumbered IP address
is configured.
Start or stop the interface. If the interface
is stopped, it does not accept or send
packets.
Enter the user name used to connect to
the PPPoE or PPPoA server.
This is only available when mode is set
to pppoe or pppoa.
Enter the virtual circuit identification VCI
number. This number is provided by your
ISP.
Enter the virtual circuit identification VPI
number. This number is provided by your
ISP.
enable
up
No default.
0
35
43